Abris – heating the workplaces


A large trading hall with ceilings of 6 meters is hard to heat up in winter and it is energy-consuming. The way out of this situation is to install expensive equipment based on chillers or give each manager a mobile electric heater. But if the first option is expensive, both in purchasing and in maintenance, then the second is either unaesthetic or ineffective.


BILUX infrared electric heaters allow you to create a zonal heating area for ​​managers. Using the correct calculation of power and location, you can raise the temperature in the working area higher by 10-15°C than outside the heating zone. The arrangement of ceiling heaters will preserve the aesthetic appearance and convenience for employees.


The main indicator of a successful project is when the customer continues to implement successful technologies at other sites. This object was tested in winter, cloned and successfully implemented in three similar stores.

We recommend ordering the implementation of Bilux from our specialists

We have been implementing Bilux for 12 years, we have made a lot of mistakes and know what to do in difficult cases. If an inexperienced installer is involved in the installation, we cannot guarantee that the heater will operate at maximum efficiency.
During installation, the installers take into account the height of the ceilings, wall thickness and location of the windows, and ensure fire and electrical safety.

Do not install heaters yourself

Example. The workshop employees bought three of the most powerful ceiling heaters and installed them themselves at a height of 3 meters at the edges and in the middle of the room. It was still cold in the workshop.
When a specialist is involved in the implementation, he makes a heat calculation and selects the power and number of heaters, chooses the right places for installation.
In the workshop, it was necessary to hang five low-power heaters around the perimeter.
The specialist checks the heat losses and, if necessary, advises thermal insulation. In the workshop, it was necessary to insulate the floor.
The specialist takes into account the height of the ceilings and the proportions of the room. In the workshop, it was necessary to hang the heaters half a meter lower.