Heating the “Marita” factory

The factory exists several dozens of years. During this time installed heating system was not updated and therefore was completely exhausted. There was a question: what kind of heating system to install on the factory.


The heating costs were constantly raising using the old heating system, so the task was to implement an alternative heating system that would allow to maintain the temperature in the premises not lower than +20°C in winter time and would reduce monthly heating bills.


Heating for the factory was decided to be realized with the help of BILUX infrared heaters. They allow to warm up the premise completely, maintain night and day temperature modes, are completely autonomous, do not make noise and do not occupy space along the walls.


Heating bills decreased by 2 times.

We recommend ordering the implementation of Bilux from our specialists

We have been implementing Bilux for 12 years, we have made a lot of mistakes and know what to do in difficult cases. If an inexperienced installer is involved in the installation, we cannot guarantee that the heater will operate at maximum efficiency.
During installation, the installers take into account the height of the ceilings, wall thickness and location of the windows, and ensure fire and electrical safety.

Do not install heaters yourself

Example. The workshop employees bought three of the most powerful ceiling heaters and installed them themselves at a height of 3 meters at the edges and in the middle of the room. It was still cold in the workshop.
When a specialist is involved in the implementation, he makes a heat calculation and selects the power and number of heaters, chooses the right places for installation.
In the workshop, it was necessary to hang five low-power heaters around the perimeter.
The specialist checks the heat losses and, if necessary, advises thermal insulation. In the workshop, it was necessary to insulate the floor.
The specialist takes into account the height of the ceilings and the proportions of the room. In the workshop, it was necessary to hang the heaters half a meter lower.