Mid-wave heater Y12000
Heat calculation
Result
Bilux Power
1 574 W
The power of traditional heating
2 430 W
Recommended heaters
Any questions?
Technical Specifications heater Y12000
Power rating, W.
11280
Voltage, V
380/400
Overall dimensions, mm
1930/622/80
Heating m2 (main)
до 90
Height of suspension on the wall, m
4-6
Height of suspension on the ceiling, m
4,5-20
Warranty, months
12
Weight, kg
30,6
Purpose of the heater heater Y12000
Mid-wave infrared heater. Strong heat flow and good dispersion spectrum are the hallmarks of the Bilux U 12000. Therefore, it is not only used for zone heating, but also as the main heat source. The heater Bilux U 12000 mounted hard to the ceiling or mounted on decorative chains or rope. Install the infrared heater should be parallel to the floor - so the performance is 100%. If there are peculiarities in the layout and design of the room, the Bilux U 12000 can be placed at an angle. But in this case, the loss of efficiency will be about 30%. Installation is carried out with the help of special fasteners.
Objects of use
- Tennis courts
- Theaters and Stages
- Gyms and swimming pools
- Crane girder workshops and hangars
- Quick-mounted buildings (QMF)
Heat calculation
Result
Bilux Power
1 574 W
The power of traditional heating
2 430 W
Recommended heaters
Any questions?
Heating the “Electromashina” plant
View
Warehouse “Kladovka”
View
Abris – heating the workplaces
View
Shop “Tabakerochka”
View
Shop “ALLO”
View
Heating the “Marita” factory
View
Heating the coffee house
View
Zhovkovsky Castle
View
Heating of the restaurant “Persha Lvivska Grilova Restaurant of the Ministry of Justice and Justice”
ViewWe recommend ordering the implementation of Bilux from our specialists
We have been implementing Bilux for 12 years, we have made a lot of mistakes and know what to do in difficult cases. If an inexperienced installer is involved in the installation, we cannot guarantee that the heater will operate at maximum efficiency.
During installation, the installers take into account the height of the ceilings, wall thickness and location of the windows, and ensure fire and electrical safety.
Do not install heaters yourself
Example. The workshop employees bought three of the most powerful ceiling heaters and installed them themselves at a height of 3 meters at the edges and in the middle of the room. It was still cold in the workshop.When a specialist is involved in the implementation, he makes a heat calculation and selects the power and number of heaters, chooses the right places for installation.
In the workshop, it was necessary to hang five low-power heaters around the perimeter.
The specialist checks the heat losses and, if necessary, advises thermal insulation. In the workshop, it was necessary to insulate the floor.
The specialist takes into account the height of the ceilings and the proportions of the room. In the workshop, it was necessary to hang the heaters half a meter lower.
The specialist checks the heat losses and, if necessary, advises thermal insulation. In the workshop, it was necessary to insulate the floor.
The specialist takes into account the height of the ceilings and the proportions of the room. In the workshop, it was necessary to hang the heaters half a meter lower.